Installation guide

Sun StorageTek Common Array Manager Software Release Notes 35
Workaround – If the queue includes multiple jobs for the array to perform, the job
can be cancelled at the point where the GUI sends the next job to the array.
Ports Link Status Down when Functioning
Bug 6650124 –Sometimes the link status of all ports (A1, A2, A3, B1, B2, and B3)
when viewed by CAM are reported as down when they are functioning properly.
This was tested with CAM Build 6.0.1.10 and ST2530.
Workaround – This bug is fixed in CAM Build 6.0.1.11.
Registration Page Displays Upon Initial Installation
When you install the Common Array Manager software for the first time, upon
logging into the browser user interface, a registration page will display. Fill out the
information before continuing.
During the initial storage array registration process, Common Array Manager
prompts you to register with the Auto Service Request service by displaying the
Auto Service Request (ASR) Setup page. This page continues to display until you
either fill out the page and click OK, or click Decline to either decline or defer ASR
service registration.
Note – You must register the array with ASR before using the Test button.
Service Advisor does not Contain Information about Disk Initialization
Bug 6602902 –When a virtual disk is in a failed state and the drive causing the
failure has been replaced, for the recommended action, the management software
refers the user to access Service Advisor to initialize the disk. However, Service
Advisor does not contain information about disk initialization and the link
erroneously accesses the Collect Support Data page.
Service Advisor does not Manage Data Channels 3 and 4
Bug 6604026 –Data channels 3 and 4 cannot be managed using Service Advisor; only
channels 1 and 2 are available for management.