Installation guide

34 Book Title without trademarks, or an abbreviated book title • March 2008
Defragmentation Jobs may not Display in the Jobs Summary Page
Bug 6592811 –For small virtual disks, disk defragmentation jobs may complete too
quickly for a job task to be created and listed on the Jobs Summary page. If an error
does occur during execution, the user will be notified.
Workaround –Run defragmentation jobs using the CLI.
Drive Order Cannot Be Specified During Volume Creation
Bug 6515237 –Common Array Manager does not allow the disk drive order to be
specified during volume creation.
Workaround – Use the CLI to specify disk drive order.
Error Message During Data Replication Configuration is Misleading
Bug 6498717 –When creating a data replication set, if the primary array cannot
communicate with the secondary array, a misleading error message displays stating
that it is “unable to get volume candidate list from array.”
Workaround – Verify that the arrays can communicate before replicating data.
Errors - General Password Mismatch
Bug 6590097, 6577775, 6592717, 6592703 –Using an invalid array password may
result in configuration error messages.
Workaround – Use the correct array password.
Install Lockhart and its L10N Packages before installing CAM in a
Sparse-Root Zone
Bug 6661200 – Lockhart 3.0.4 cannot be installed or upgraded in a sparse-root zone.
Workaround – Before you install CAM in a sparse-root zone, install Lockhart 3.0.4
with its L10N packages in the global zone.
Jobs Checkbox does not Display; Job will not Cancel
Bug 6600387 – When a long job is running, such as large volume creation, the Cancel
checkbox does not display on current job status. Some jobs cannot be cancelled once
they have started on the array.