Installation guide

[root@rh4cluster1 ~]# multipath -v2
create: SIBM-ESXSST336732LC____F3ET0EP0Q000072428BX1
[size=33 GB][features="0"][hwhandler="0"]
\_ round-robin 0
\_ 0:0:0:0 sda 8:0 [---------
device-mapper ioctl cmd 9 failed: Invalid argument
device-mapper ioctl cmd 14 failed: No such device or address
create: 3600a0b80001327d80000006d43621677
[size=12 GB][features="0"][hwhandler="0"]
\_ round-robin 0
\_ 2:0:0:0 sdb 8:16
\_ 3:0:0:0 sdf 8:80
create: 3600a0b80001327510000009a436215ec
[size=12 GB][features="0"][hwhandler="0"]
\_ round-robin 0
\_ 2:0:0:1 sdc 8:32
\_ 3:0:0:1 sdg 8:96
create: 3600a0b80001327d800000070436216b3
[size=12 GB][features="0"][hwhandler="0"]
\_ round-robin 0
\_ 2:0:0:2 sdd 8:48
\_ 3:0:0:2 sdh 8:112
create: 3600a0b80001327510000009b4362163e
[size=12 GB][features="0"][hwhandler="0"]
\_ round-robin 0
\_ 2:0:0:3 sde 8:64
\_ 3:0:0:3 sdi 8:128
2. In order to prevent the device mapper from mapping /dev/sda in its multipath maps, edit the
devnode_blacklist section of the /etc/multipath.conf file to include this device.
Although you could blacklist the sda device using a devnode type, that would not be safe
procedure since /dev/sda is not guaranteed to be the same on reboot. T o blacklist individual
devices, you can blacklist using the WWID of that device.
Note that in the output to the m ultipath -vs command, the WWID of the /dev/sda device is
SIBM-ESXSST336732LC____F3ET0EP0Q000072428BX1. To blacklist this device, include the
following in the /etc/m ultipath.conf file.
devnode_blacklist {
wwid SIBM-ESXSST336732LC____F3ET0EP0Q000072428BX1
}
3. Run the following commands:
multipath -F
multipath -v2
The local disk or disks should no longer be listed in the new multipath maps, as shown in the
following example.
Red Hat Enterprise Linux 4 DM Multipath
16