Service manual

Chapter 6 Replacing Parts
89
The plastic latch (6), which holds the PCI board in place, is hinge mounted on a molded plastic frame and the
plastic frame is inserted into metal shell secured to the rear of the chassis with four (4) screws. The blue
plastic tabs are individual mounted on metal posts that remain in the chassis.
1. Log off all users and if necessary back-up files.
2. Follow instructions in your network operating system (NOS) documentation to gracefully shut
down all networking software and applications.
3. Press the power switch on the HP NetServer's control panel when prompted by the operating
system.
4. Disconnect the power cables.
WARNING The power supplies will continue to provide standby current to the NetServer until
the power cord(s) is/are disconnected.
5. Remove the left (or top) cover to access the inside of the chassis by referring to:
à Replacing the Covers
6. Open all six blue tabs to release the PCI latch hardware.
7. Remove the two screws underneath the PCI latch hardware, using a T-15 Torx driver.
8. Remove the two screws at the rear of the PCI latch hardware, using a T-15 Torx driver.
9. Pull the PCI latch hardware out of the NetServer.
Open Blue Tab
PCI Latch and Tab Hardware
10. To remove the individual blue tab, remove the respective screw for the desired blue tab.
11. To install the PCI latch hardware and the blue tabs, reverse Steps,
Replacing a Power Supply