Service manual

Chapter 1 General Information
3
12. To replace the left side cover, position the cover’s tabs next to the respective holes along the
outer edge on the side of the chassis.
13. Slide the cover toward the rear.
14. Tighten the thumbscrew at the front of the cover.
15. To replace the right side cover, position the cover’s tabs next to the respective holes along the
outer edge on each side of the chassis.
16. Slide the cover toward the rear.
17. Tighten the thumbscrew at the front of the chassis.
18. To replace the bezel, insert the tabs at the bottom of the bezel into the slots on the chassis.
19. Swing the top of the bezel toward the chassis until it snaps into place.
Replacing the Bezel
20. Return the HP NetServer to normal operation.
Removing Covers - Rack Mount (LC 2000r)
Remove the bezel and then safely extend the rack-mounted HP NetServer LC 2000r from the rack, where
you can remove the covers (top and bottom).
• If you are installing hardware options, you must remove the front bezel, extend the NetServer,
and then remove the top cover. The hardware options include accessory boards, DIMMs, and
an additional processor, which require access to the interior of the NetServer.
• If you are only installing or removing SCSI Hot Swap disk drives, open the bezel, but do not
extend the NetServer or remove the covers. The front bezel is hinged like a door and does not
require removal.
l If you are only installing the redundant power supply, you do not need to remove the bezel,
extend the NetServer, or remove the covers.
WARNING To prevent injury do not operate the HP NetServer with its covers removed or install
items with the power cord connected.