Service manual

Chapter 6 Replacing Parts
79
WARNING The power supplies will continue to provide standby current to the NetServer until
the power cable is disconnected.
5. Gain access to the HP NetServer by referring to Replacing the Bezel and Replacing the
Covers.
CAUTION Wear a wrist strap and use a static-dissipating work surface connected to the
chassis when handling components. Ensure that the metal of the wrist strap
contacts your skin.
6. Remove the fan module from the fan tray.
You may need a T-15 driver to loosen the thumbscrew on the back of the fan tray.
Thumbscrew
on back of fan
module
Fan Module Removal
7. Disconnect the Duplex card cable from the back of the Hot Swap cage.
NOTE Figures are shown with the SCSI data and power cables removed for clarity.
However, is not necessary to remove these cables from the rear of the Hot Swap
cage to remove the Duplex card.