Service manual

Chapter 6 Replacing Parts
78
Screws Holding Hot Swap Cage to Chassis
10. Slide the hot swap cage forward and out of the chassis.
Replacing the Hot Swap Drive Cage
NOTE If you have a Duplex card on the drive cage you are removing, you may choose to
move it to the new drive cage. Refer to Replacing the Duplex Card.
1. Slide the replacement drive cage into the chassis.
2. Reconnect the SCSI data and power cables to the rear of the chassis.
3. Re-install the fan module.
4. Re-assemble the NetServer and resume operations.
NOTE Be aware of firmware upgrades that affect your NetServer's SCSI subsystem. Use a
current Navigator CD ROM to check if firmware updates are required.
Replacing the Duplex Card
The duplex card is used to split the Hot Swap Storage Cage into to two equal parts or two SCSI channels.
The Duplex Card mounts on the back of the hot-swap card cage. Refer to Replacing the Hot-Swap Cage.
1. Log off all users and if necessary, back-up files.
2. Follow instructions in your network operating system (NOS) documentation to gracefully shut
down all networking software and applications.
3. Press the power switch on the HP NetServer's control panel when prompted by the operating
system.
4. Disconnect the power cables.