Service manual

Chapter 6 Replacing Parts
73
3. Press the power switch on the HP NetServer's control panel when prompted by the operating
system.
4. Disconnect the power cables.
WARNING The power supplies will continue to provide standby current to the NetServer until
the power cord(s) is/are disconnected.
5. Gain access to the NetServer by referring to:
à Replacing the Bezel
à Replacing Covers
6. Remove the control cable connected to the system board.
7. Remove the cable from the cable harness and pass the end through the opening between the
non-hot swap cage and the Hot Swap mass storage cage.
NOTE You may find it necessary to remove the entire Fan Assembly (Fan Module and Fan
Tray).
8. At the right side (LC 2000) or bottom (LC 2000r) of the NetServer remove the two screws
holding the control panel board in place, using a T-15 Torx driver.
CAUTION Wear a wrist strap and use a static-dissipating work surface connected to the
chassis when handling components. Ensure the metal of the wrist strap contacts
your skin.
9. Pull the control panel board and cable out of the NetServer.
Control Panel Board Location
10. To install the Control Panel Board, reverse Steps 1-9 and insert the end of the board into the
metal slot just above the Hot Swap mass storage cage.