Service manual

Chapter 6 Replacing Parts

4. Disconnect the power cables.

WARNING The power supplies will continue to provide standby current to the NetServer until

the power cable is disconnected.

5. Gain access to the HP NetServer by referring to Replacing the Bezel and Replacing the Covers.

CAUTION Wear a wrist strap and use a static-dissipating work surface connected to the

chassis when handling components. Ensure that the metal of the wrist strap

contacts your skin.

6. Remove power and signal cables from the rear of the CD ROM drive.

7. Use the T-15 driver to remove the two screws that hold the CD-ROM drive to the chassis.

Removing the CD ROM Drive

8. Slide the CD-ROM drive forward and out of the chassis.

Replacing the CD ROM Drive

Move the CD-ROM drive mounting bracket from the failed drive to the replacement drive and reverse the

above procedure.

NOTE The CD ROM connectors are keyed. Ensure the cables are fully seated.

Replacing the Control Panel

The same control panel board is used in both models of the HP NetServers (LC 2000/LC 2000r). This board

can only be accessed by shutting down the system and removing both covers, that is, left and right side

covers (pedestal version) or top and bottom covers (rack version).

1. Log off all users and if necessary back-up files.

2. Follow instructions in your network operating system (NOS) documentation to gracefully shut

down all networking software and applications.