Service manual

Chapter 6 Replacing Parts

You must remove the bezel to remove the other covers from the HP NetServer or to access front-end

components.

1. To remove the bezel, pull the top of the bezel forward until it un-snaps, then lift the entire bezel

upward and away from the chassis.

The bezel connects to the front of the HP NetServer chassis with two snap-in connectors at the

top front of the chassis and two metal tabs, which fit into two slots on the bottom front of the

chassis.

Removing the HP NetServer LC 2000 Bezel

Replacing the Pedestal Bezel

1. To replace the bezel, insert the tabs at the bottom of the bezel into the slots on the chassis.

2. Swing the top of the bezel toward the chassis until it snaps into place.

Replacing the Bezel

Removing the Rack Bezel

1. Swing open the bezel to the left to access the Bezel Release Tab.

2. Press down on the Blue Tab to release the bezel from the HP NetServer.