Service manual

Chapter 6 Replacing Parts
68
5. Turn the NetServer onto its top.
6. Pull up on the two tabs.
NOTE The front bezel may remain in place while the pedestal is removed. The figure below
is shown with the bezel removed, but is not required.
Removing the Pedesal
7. Slide the pedestal to the rear of the NetServer.
Replacing the Pedestal Base
l To re-install the pedestal, reverse Steps 1-6 and slide the pedestal forward onto the NetServer.
Replacing the System Battery
Use this topic to replace the system battery, which uses a Lithium battery to support the real time (Time and
Date) clock and configuration data in NVRAM. If your HP NetServer repeatedly loses its configuration, or the
time of day clock stops, replace the battery.
System battery failure is normally signaled by POST error code 011.
WARNING There is a danger of explosion if the battery is incorrectly installed. Replace only
with the same or equivalent type recommended by the manufacturer. Dispose of
used batteries safely in accordance with local ordinances.
1. Log off all users and if necessary, back-up files.
2. Follow instructions in your network operating system (NOS) documentation to gracefully shut
down all networking software and applications.