Service manual

Chapter 4 Diagnostics
41
6. If the error persists, the system board may need to be
replaced. Contact your service representative.
0901 Integrated LAN
enable error
The system could not enable the integrated LAN.
To correct this:
1. Reset the Integrated LAN by powering off the HP NetServer.
2. Disconnecting the power cord for 20 seconds.
3. Reconnect the power cord and power on the HP NetServer.
4. If the error appears upon restarting, update the system BIOS.
5. Insert the HP Navigator CD-ROM in the CD-ROM drive and
power-cycle your system.
This will initialize the flash utility on HP Navigator CD-ROM.
6. If the error persists, the system board may need to be
replaced. Contact your service representative.
0A00 Display refresh
rate error
The parameters returned by the display do not match the DDC
standard used by the NetServer for automatic setup of ergonomic
refresh rates.
To correct this:
1. Disable the 'Plug & Play Display' feature in the Setup Utility to
avoid a blank or unreadable screen at power-up.
2. Use the Setup Utility to manually set the video refresh rates to
the highest ergonomic refresh rates supported by the display.
Refer to display monitor's User's Guide for specifications.
0B3x Processor
Module conflict
POST has detected the processor modules installed in the NetServer
are not the same type or speed.
To correct this:
1. Ensure both processor modules in the NetServer have the
same product code, which should include the type, heat sink,
and speed.
2. If not, replace one or both to ensure both are the same
product code. Contact your service representative.
This problem must be corrected to avoid possible malfunction
or reliability problems.