Service manual

Chapter 4 Diagnostics
39
message
applies only to
the IDE cable
(primary
channel)
marked IDE
cable <#0530>.
The secondary
channel cable
marked IDE2
<#0531> does
not apply to the
LC 2000.)
hard drive and use the other connector to re-connect the hard
drive into the first <master> position.
2. If two disks are connected on the cable, verify all data cables
and power cables are firmly connected for both hard disk
drives.
3. If the error message appears just after a hard disk drive
installation, check for master/slave specific jumper
configurations in the hard disk drive installation manual.
4. If the problem persists, the hard disk drive may need to be
replaced. Contact your service representative.
0540 Hard Disk
Controller
resource
conflict
POST has detected an address space or IRQ resource conflict
between the integrated hard disk controller and an accessory board.
To correct this:
1. If the integrated hard disk controller is not needed, run the
Setup Utility to disable it (primary or secondary).
2. If the integrated hard disk controller is needed, the accessory
board's IRQ and address space must be reconfigured to use
other free resources. Refer to the accessory board installation
manual for information.
0600 Video Memory
boot error
The video memory size detected during POST is smaller than
previously detected. (This would only apply if a video adapter board
were installed into LC 2000, because the user wanted a faster video
board with more memory, or the embedded video circuitry was
defective.)
To correct this:
1. If you have changed your video adapter, press <F4> to
automatically validate the change.
2. If the problem persists, the system board or video board may
need to be replaced. Contact your service representative.
0700 DIMM size boot
error
The system memory size detected during the POST is smaller than
previously detected. One or several DIMMs are either disconnected, or
have been replaced by smaller ones.
To correct this:
1. If some main DIMMs have just been removed or replaced by
smaller ones, press <F4> to automatically validate the
change.
2. If no DIMM has been removed or changed, ensure all DIMMs
are properly inserted in the slots.
3. If the problem persists, one of DIMMs may need to be
replaced. Contact your service representative.
0712 DIMM
installation
error
POST has detected an incorrectly installed DIMM or the failure of one
or more DIMMs.