Service manual

Chapter 4 Diagnostics
37
replaced. Contact your service representative.
0307 Flexible disk
drive controller
resource
conflict
POST has detected an address space or IRQ resources conflict
between the integrated flexible disk controller and an accessory board.
To correct this:
1. If the integrated flexible disk controller is not needed, run the
Setup Utility and disable the flexible disk controller.
2. If the integrated flexible disk controller is needed, the
accessory board's IRQ and address space must be
reconfigured to use other free resources. Refer to the
accessory board installation manual for information.
0400 CD-ROM boot
error
POST has detected the CD-ROM drive has reported an error during its
self-test.
To correct this:
1. If a CD-ROM disk is present, verify it is correctly inserted.
2. Verify the CD-ROM drive door or tray has not been opened or
closed during the self-test.
3. Verify all data cables and power cables are firmly connected.
4. If the problem persists, your CD-ROM drive may need to be
replaced. Contact your service representative.
0401 CD-ROM drive
not responding
POST has detected the CD-ROM drive is not responding, but is
configured in the Setup Utility.
To correct this:
1. If the CD-ROM drive has just been removed, press <F4> to
automatically validate the change.
2. Verify all data cables and power cables are firmly connected.
3. If the cable is damaged, connect the hard disk drive to another
IDE cable, if available. The Setup Utility and the 32-bit disk
access driver may need to be modified accordingly.
4. If the problem persists, your CD-ROM drive may need to be
replaced. Contact your service representative.
0500 Hard Disk
(primary)
controller boot
error
POST has detected a general failure on the integrated (primary) hard
disk controller.
To correct this:
1. Restart your HP NetServer.
2. If the error persists, your system board may need to be
replaced. Contact your service representative.
(This following does not apply to the LC 2000.)
1. If no device uses the other IDE channel, connect your hard
disk drive to the other cable to operate with the secondary
controller. Verify the secondary IDE controller is enabled in