Service manual

Chapter 4 Diagnostics
35
2. If the error persists, your system board may need to be
replaced. Contact your service representative.
0103 Keyboard is not
connected.
POST has detected the keyboard is not connected.
To correct this:
1. Verify the keyboard connector is firmly connected.
2. Reboot the NetServer.
3. If the problem persists, your keyboard cable may be damaged
or your keyboard may need to be replaced. Contact your
service representative.
0105 Mouse boot
error
The system board has detected a mouse error during POST.
To correct this:
1. Clean the mouse and its moving ball as described in the
User's Guide.
2. If the problem persists, your mouse may need to be replaced.
Contact your service representative.
0106 Mouse is not
responding.
The system board has detected the mouse is not responding.
To correct this:
1. If the mouse has just been removed, press <Esc > to
automatically validate the change.
2. Otherwise, verify the mouse connector is firmly connected.
3. If the problem persists, your mouse may need to be replaced.
Contact your service representative.
0108 Mouse and
Keyboard
reversed
POST has detected the mouse and keyboard connections are
reversed.
To correct this:
1. Turn the NetServer off.
2. Swap the mouse and keyboard connections.
3. Turn on the NetServer power and reboot the NetServer.
0200 Serial Port
Controller
resource
conflict
POST has detected an address space or IRQ resource conflict
between one of the integrated serial port controllers and an accessory
board.
To correct this:
1. If an integrated serial port is not needed, run the Setup Utility
and disable the related serial port.
2. If the integrated serial port is needed and its settings cannot
be modified, the accessory board's IRQ and address space
must be reconfigured to use other free resources. Refer to the
accessory board installation manual for information.