Service manual

Chapter 4 Diagnostics
34
3. Run the Plug & Play utility supported by your Operating
System.
4. If the problem persists, the accessory board may be defective.
Contact the accessory board vendor.
0030 Processor
Speed
selection
problem
POST has detected the processor speed selected with system board
switches does not match the processor's speed.
Refer to the User's guide for the correct switch setting.
0040 PC Serial
Number
initialization
problem
POST has detected the PC Serial Number has been lost or has not
been initialized.
Pressing <F2> will automatically run the HP Serial (BIOS) Utility and
allow you to enter the Serial Number.
0050 Processor
Cooling/Heatin
g problem
POST has detected a cooling fan problem.
The processor cooling-fan needs to be connected.
0076 Integrated HP
NetRAID
processor is
not responding.
(This does not
apply to
LC2000)
This problem will prevent the operation of the Integrated HP NetRAID,
if it is enabled. The problem may also prevent operation of some PCI
slots.
1. Flash the Integrated HP NetRAID firmware and reboot the
system.
2. If the error persists, your I/O board may need to be replaced.
Contact your service representative.
0100 Keyboard error
during POST
A key on the keyboard has been pressed during POST of the HP
NetServer.
To correct this:
1. Ensure nothing is put on the keyboard and no key is
accidentally pressed down.
2. Reboot the NetServer.
3. If the error persists, your keyboard may need to be replaced.
Contact your service representative.
0101 Keyboard error The keyboard has reported an error during its self-test.
To correct this:
1. Restart your HP NetServer.
2. If the error persists, your keyboard may need to be replaced.
Contact your service representative.
0102 Keyboard
controller error
during POST
POST has detected a general failure in the integrated keyboard
controller.
To verify this error:
1. Restart your HP NetServer.