Service manual

Chapter 4 Diagnostics
33
0011 Battery
problem
The NetServer BIOS is not responding due to a possible battery
discharge. If the HP NetServer was unplugged for a long period of
time, the battery will discharge and not provide enough current to keep
the system date and time current.
To correct this:
1. Verify the battery is properly inserted.
2. If necessary, replace the battery.
3. Set time and date using the Setup Utility and your operating
system, if necessary.
0012 BIOS
initialization
problem
The HP NetServer configuration has been cleared or has not been
initialized.
Run the Setup Utility to re-configure your system.
0020 ISA
initialization
problem
The ROM on the accessory board is bad or the board has a conflict
with a system board reserved resource (address, DMA, or IRQ).
To correct this:
1. Change the resources used by the ISA accessory boards.
2. Try to disable <free> resources used by system board
devices.
3. If the problem persists, the accessory board may be defective.
Contact the accessory board vendor.
0021 PCI
Configuration
conflict
A configuration problem has occurred with a PCI device. The PCI
device or accessory board doesn’t match PC setup settings or has
conflicts with PC resources (reserved memory space, IRQ or DMA
channels).
To correct this:
1. Clear the PCI configuration with the CMOS status switch.
Refer to the User's guide for details.
2. If necessary, use the Setup Utility to manually configure the
PCI devices.
3. Check for any further PC resource, which can be used. Use
Setup Utility to disable any unused function, such as I/O ports
or IDE controllers.
4. Start the Operating System and let it update the PCI
configuration.
0022 Plug & Play
ISA
initialization
problem
The Plug & Plug ISA accessory board has reported an initialization
problem. The ROM on the accessory board is bad or the Plug & Play
BIOS cannot solve a conflict issue with a system board reserved
resource.
To correct this:
1. Clear the Plug & Play configuration with the CMOS status
switch. Refer to the User's guide for details.
2. Try to disable (free) resources used by system board devices.