Service manual

Chapter 1 General Information
7
The bottom cover does not provide any additional access to the interior, except the bottom of
the mass storage drives and the control panel board.
16. Support the bottom cover with your free hand, as you pull the cover forward to disengage it,
catching it as it falls away from the chassis.
17. To replace the top cover, position the cover’s tabs over the respective holes along the top edge
on both sides of the chassis.
18. Slide the cover toward the rear.
19. Tighten the thumbscrew at the front of the cover.
20. To replace the bottom cover, position the cover’s tabs under the respective holes along the
bottom edge on both sides of the chassis.
21. Slide the cover toward the rear.
22. Tighten the thumbscrew at the front of the cover.
23. Release the safety latches in the slide members on both sides of the chassis.
24. Slide the HP NetServer into the rack.
25. To replace the front bezel, reverse the procedure by positioning the bezel over the hinge pins at
the front of the HP NetServer’s chassis.
26. Press the down on the Blue Bezel Release tab to engage the hinge pins of the bezel and then
release it.
27. If the NetServer is not in a restricted-access area, tighten both slide-securing screws.
28. Return the HP NetServer to normal operation.
Lights and Indicators
Front Panel
RES
ET
RESE
D
i
s
k
F
a
n
T
e
m
p
e
r
a
t
u
r
e
P
o
w
e
r
S
u
p
p
l
y
Power
Button
Reset
Button
Keyboard Lock
Button
Cover Removed
for Clarity
Keyboard
Lock LED
Power LED
R
e
s
e
r
v
e
d
HP NetServer LC 2000 (front view)