Installation guide

( xen d - relo cat io n - ad d ress) Determines the host addresses allowed for
migration. The default value is the value of
xend-address.
( xen d - ad d ress) Determines the address that the domain socket
server binds to. The default value allows all
connections.
It em Descrip t io n
After setting these operating parameters, you should verify that xend is running and if not, initialize
the daemon. At the command prompt, you can start the xen d daemon by entering the following:
service xend start
You can use xen d to stop the daemon:
service xend stop
This stops the daemon from running.
You can use xen d to restart the daemon:
service xend restart
The daemon starts once again.
You check the status of the xen d daemon.
service xend status
The output displays the daemon's status.
Note
Use the chkconfig command to add the xend to the initscript.
chkconfig --level 345 xend
The xend will now start in runlevels 3, 4 and 5.
Red Hat En t erp rise Lin ux 5 Virt ualizat ion Guid e
220