Installation guide

Physical volume "/dev/sdf2" successfully created
Physical volume "/dev/sdg1" successfully created
Physical volume "/dev/sdg2" successfully created
Physical volume "/dev/sdh1" successfully created
Physical volume "/dev/sdh2" successfully created
The following commands creates the volume group vg and the mirrored volume groupfs.
[root@link-08 ~]# vgcreate vg /dev/sd[abcdefgh][12]
Volume group "vg" successfully created
[root@link-08 ~]# lvcreate -L 750M -n groupfs -m 1 vg /dev/sda1 /dev/sdb1 /dev/sdc1
Rounding up size to full physical extent 752.00 MB
Logical volume "groupfs" created
You can use the lvs command to verify the layout of the mirrored volume and the underlying
devices for the mirror leg and the mirror log. Note that in the first example the mirror is not yet
completely synced; you should wait until the Copy% field displays 100.00 before continuing.
[root@link-08 ~]# lvs -a -o +devices
LV VG Attr LSize Origin Snap% Move Log Copy% Devices
groupfs vg mwi-a- 752.00M groupfs_mlog 21.28 groupfs_mimage_0(0),groupfs_mimage_1(0)
[groupfs_mimage_0] vg iwi-ao 752.00M /dev/sda1(0)
[groupfs_mimage_1] vg iwi-ao 752.00M /dev/sdb1(0)
[groupfs_mlog] vg lwi-ao 4.00M /dev/sdc1(0)
[root@link-08 ~]# lvs -a -o +devices
LV VG Attr LSize Origin Snap% Move Log Copy% Devices
groupfs vg mwi-a- 752.00M groupfs_mlog 100.00 groupfs_mimage_0(0),groupfs_mimage_1(0)
[groupfs_mimage_0] vg iwi-ao 752.00M /dev/sda1(0)
[groupfs_mimage_1] vg iwi-ao 752.00M /dev/sdb1(0)
[groupfs_mlog] vg lwi-ao 4.00M i /dev/sdc1(0)
In this example, the primary leg of the mirror /dev/sda1 fails. Any write activity to the mirrored
volume causes LVM to detect the failed mirror. When this occurs, LVM converts the mirror into a
single linear volume. In this case, to trigger the conversion, we execute a dd command
[root@link-08 ~]# dd if=/dev/zero of=/dev/vg/groupfs count=10
10+0 records in
10+0 records out
You can use the lvs command to verify that the device is now a linear device. Because of the
failed disk, I/O errors occur.
[root@link-08 ~]# lvs -a -o +devices
/dev/sda1: read failed after 0 of 2048 at 0: Input/output error
/dev/sda2: read failed after 0 of 2048 at 0: Input/output error
LV VG Attr LSize Origin Snap% Move Log Copy% Devices
groupfs vg -wi-a- 752.00M /dev/sdb1(0)
At this point you should still be able to use the logical volume, but there will be no mirror redund-
ancy.
To rebuild the mirrored volume, you replace the broken drive and recreate the physical volume.
If you use the same disk rather than replacing it with a new one, you will see "inconsistent"
warnings when you run the pvcreate command.
3. Recovering from LVM Mirror Failure
61