Installation guide

dd if=/dev/zero of=PhysicalVolume bs=512 count=1
2.1.2. Initializing Physical Volumes
Use the pvcreate command to initialize a block device to be used as a physical volume. Initializ-
ation is analogous to formatting a file system.
The following command initializes /dev/sdd1, /dev/sde1, and /dev/sdf1 for use as LVM physical
volumes.
pvcreate /dev/sdd1 /dev/sde1 /dev/sdf1
To initialize partitions rather than whole disks: run the pvcreate command on the partition. The
following example initializes /dev/hdb1 as an LVM physical volume for later use as part of an
LVM logical volume.
pvcreate /dev/hdb1
2.1.3. Scanning for Block Devices
You can scan for block devices that may be used as physical volumes with the lvmdiskscan
command, as shown in the following example.
# lvmdiskscan
/dev/ram0 [ 16.00 MB]
/dev/sda [ 17.15 GB]
/dev/root [ 13.69 GB]
/dev/ram [ 16.00 MB]
/dev/sda1 [ 17.14 GB] LVM physical volume
/dev/VolGroup00/LogVol01 [ 512.00 MB]
/dev/ram2 [ 16.00 MB]
/dev/new_vg/lvol0 [ 52.00 MB]
/dev/ram3 [ 16.00 MB]
/dev/pkl_new_vg/sparkie_lv [ 7.14 GB]
/dev/ram4 [ 16.00 MB]
/dev/ram5 [ 16.00 MB]
/dev/ram6 [ 16.00 MB]
/dev/ram7 [ 16.00 MB]
/dev/ram8 [ 16.00 MB]
/dev/ram9 [ 16.00 MB]
/dev/ram10 [ 16.00 MB]
/dev/ram11 [ 16.00 MB]
/dev/ram12 [ 16.00 MB]
/dev/ram13 [ 16.00 MB]
/dev/ram14 [ 16.00 MB]
/dev/ram15 [ 16.00 MB]
/dev/sdb [ 17.15 GB]
/dev/sdb1 [ 17.14 GB] LVM physical volume
/dev/sdc [ 17.15 GB]
/dev/sdc1 [ 17.14 GB] LVM physical volume
/dev/sdd [ 17.15 GB]
/dev/sdd1 [ 17.14 GB] LVM physical volume
7 disks
17 partitions
0 LVM physical volume whole disks
4 LVM physical volumes
2.2. Displaying Physical Volumes
20