Installation guide

• Section 6.1, “Adding a Failover Domain”
• Section 6.2, “Removing a Failover Domain”
• Section 6.3, “Removing a Member from a Failover Domain”
6.1. Adding a Failover Domain
To add a failover domain, follow these steps:
1. At the left frame of the Cluster Configuration Tool, click Failover Domains.
2. At the bottom of the right frame (labeled Properties), click the Create a Failover Domain
button. Clicking the Create a Failover Domain button causes the Add Failover Domain
dialog box to be displayed.
3. At the Add Failover Domain dialog box, specify a failover domain name at the Name for
new Failover Domain text box and click OK. Clicking OK causes the Failover Domain
Configuration dialog box to be displayed (Figure 5.7, “Failover Domain Configuration:
Configuring a Failover Domain”).
Note
The name should be descriptive enough to distinguish its purpose relative to
other names used in your cluster.
Chapter 5. Configuring Red Hat Cluster With system-config-cluster
66