Installation guide

may vary among computers. However, the objective of this procedure is to

configure the BIOS so that the computer is turned off via the power button

without delay.

4. Exit the BIOS CMOS Setup Utility program, saving the BIOS configuration.

5. When the cluster is configured and running, verify that the node turns off immediately when

fenced.

Tip

You can fence the node with the fence_node command or Conga.

+-------------------------------------------------|------------------------+

| ACPI Function [Enabled] | Item Help |

| ACPI Suspend Type [S1(POS)] |------------------------|

| x Run VGABIOS if S3 Resume Auto | Menu Level * |

| Suspend Mode [Disabled] | |

| HDD Power Down [Disabled] | |

| Soft-Off by PWR-BTTN [Instant-Off] | |

| CPU THRM-Throttling [50.0%] | |

| Wake-Up by PCI card [Enabled] | |

| Power On by Ring [Enabled] | |

| Wake Up On LAN [Enabled] | |

| x USB KB Wake-Up From S3 Disabled | |

| Resume by Alarm [Disabled] | |

| x Date(of Month) Alarm 0 | |

| x Time(hh:mm:ss) Alarm 0 : 0 : 0 | |

| POWER ON Function [BUTTON ONLY] | |

| x KB Power ON Password Enter | |

| x Hot Key Power ON Ctrl-F1 | |

| | |

+-------------------------------------------------|------------------------+

This example shows ACPI Function set to Enabled, and Soft-Off by PWR-BTTN set to

Instant-Off.

Example 2.10. BIOS CMOS Setup Utility: Soft-Off by PWR-BTTN set to

Instant-Off

Chapter 2. Before Configuring a Red Hat Cluster