Installation guide

From this screen you can choose to disable a dmraid device, in which case the individual elements
of the dmraid device will appear as separate hard drives. You can also choose to configure an iSCSI
(SCSI over TCP/IP) target.
To configure an ISCSI target invoke the Configure ISCSI Parameters dialog by selecting Add
ISCSI target and clicking on the Add Drive button. If a network connection is not already active,
the installer prompts you to provide details of your network interface. Select your network interface
from the drop-down menu, then either leave the Use dynamic IP configuration box checked,
or uncheck it to enter the IP address of your system and the IP addresses of the gateway and
nameserver on your network. Ensure that the Enable IPv4 box remains checked.
Fig u re 4 .13. En ab le n et work In t erf ace
Fill in the details for the iSCSI target IP and provide a unique iSCSI initiator name to identify this
system. If the iSCSI target uses Challenge Handshake Authentication Protocol (CHAP) for authentication,
enter the CHAP username and password. If your environment uses 2-way CHAP (also called "Mutual
CHAP"), also enter the reverse CHAP username and password. Click the Add target button to
attempt connection to the ISCSI target using this information.
Red Hat Ent erprise Linux 5 Inst allat ion G uide
4 0