Installation guide

Make sure the SUBCHANNELS statement matches the hardware addresses for your qeth device.
/etc/sysconfig/network-scripts/ifcfg-eth1
# IBM QETH
DEVICE=eth1
BOOTPROTO=static
IPADDR=192.168.70.87
NETMASK=255.255.255.0
ONBOOT=yes
NETTYPE=qeth
SUBCHANNELS=0.0.0600,0.0.0601,0.0.0602
TYPE=Ethernet
A qeth device requires an alias definition in /etc/modprobe.conf. Edit this file and add an alias
for your interface.
/etc/modprobe.conf
alias eth0 qeth
alias eth1 qeth
options dasd_mod dasd=0.0.0100,0.0.4b19
Now you can start the new interface:
# ifup eth1
Check the status of the interface:
# ifconfig eth1
eth1 Link encap:Ethernet HWaddr 02:00:00:00:00:01
inet addr:192.168.70.87 Bcast:192.168.70.255 Mask:255.255.255.0
inet6 addr: fe80::ff:fe00:1/64 Scope:Link
UP BROADCAST RUNNING NOARP MULTICAST MTU:1492 Metric:1
RX packets:23 errors:0 dropped:0 overruns:0 frame:0
TX packets:3 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:644 (644.0 b) TX bytes:264 (264.0 b)
Note that the HWaddr field in the first line of the ifconfig command output. The value after that must
be added to the ifcfg-eth1 file. Add a line like the following to that file:
HWADDR=02:00:00:00:00:01
Now ifcfg-eth1 looks similar to the following:
# IBM QETH
DEVICE=eth1
HWADDR=02:00:00:00:00:01
BOOTPROTO=static
IPADDR=192.168.70.69
NETMASK=255.255.255.0
ONBOOT=yes
NETTYPE=qeth
SUBCHANNELS=0.0.0600,0.0.0601,0.0.0602
TYPE=Ethernet
Check the routing for the new interface:
# route
Kernel IP routing table
⁠Chapt er 2 2 . Addit ional Informat ion for IBM Syst em z Users
237