Installation guide

qeth: SUBCHANNELS="read_device_bus_id,write_device_bus_id, data_device_bus_id"
lcs: SUBCHANNELS="read_device_bus_id,write_device_bus_id"
For example (a sample qeth SUBCHANNEL statement):
SUBCHANNELS=0.0.0600,0.0.0601,0.0.0602
The following parameters are optional:
HOSTNAME=string
Where string is the hostname of the newly-installed Linux guest.
NETTYPE=type
Where type must be one of the following: lcs, or qeth.
Choose lcs for:
OSA-2 Ethernet/Token Ring
OSA-Express Fast Ethernet in non-QDIO mode
OSA-Express High Speed Token Ring in non-QDIO mode
Gigabit Ethernet in non-QDIO mode
Choose qeth for:
OSA-Express Fast Ethernet
Gigabit Ethernet (including 1000Base-T)
High Speed Token Ring
HiperSockets
ATM (running Ethernet LAN emulation)
IPADDR=IP
Where IP is the IP address of the new Linux guest.
NETWORK=network
Where network is the address of your network.
NETMASK=netmask
Where netmask is the netmask.
BROADCAST=broadcast
Where broadcast is the broadcast address.
GATEWAY=gw
Where gw is the gateway-IP for your eth device.
MTU=mtu
⁠Chapt er 1 6 . St eps t o G et You St art ed
179