Installation guide

The output is listed in the order the system was probed. So, all FAT16 file systems are listed first, then
IDE hard drives, then SCSI hard drives, then IDE CD-ROM drives, and finally SCSI CD-ROM drives.
For example, output of the map command might look like the following:
Device mapping table
fs0 : VenHw(Unknown Device:00)/HD(Part1,Sig00000000)
fs1 : VenHw(Unknown Device:80)/HD(Part1,Sig00000000)
fs2 : VenHw(Unknown Device:FF)/CDROM(Entry1)/HD(Part1,Sig00000000)
blk0 : VenHw(Unknown Device:00)
blk1 : VenHw(Unknown Device:00)/HD(Part1,Sig00000000)
blk2 : VenHw(Unknown Device:80)
blk3 : VenHw(Unknown Device:80)/HD(Part1,Sig00000000)
blk4 : VenHw(Unknown Device:80)/HD(Part2,Sig00000000)
blk5 : VenHw(Unknown Device:80)/HD(Part3,Sig00000000)
blk6 : VenHw(Unknown Device:80)/HD(Part3,Sig00000000)/HD(Part1,Sig725F7772)
blk7 : VenHw(Unknown Device:FF)
blk8 : VenHw(Unknown Device:FF)/CDROM(Entry1)
blk9 : VenHw(Unknown Device:FF)/CDROM(Entry1)/HD(Part1,Sig00000000)
In this example, there is an LS-120 diskette in the LS-120 drive as well as a CD -ROM in the CD-ROM
drive. All the listings beginning with fs are FAT16 file systems that EFI can read. All the listings
beginning with blk are block devices that EFI recognizes. Both the file systems and block devices
are listed in the order they are probed. Therefore, fs0 is the system partition on the LS-120, fs1 is
the system partition on the hard drive, and fs2 is the system partition on the CD-ROM.
1.2.2. It anium Syst ems — EFI Syst em Part it ion
When partitioning your hard drive for Linux, you must create a system partition that is FAT16 (VFAT)
formatted and has a mount point of /boot/efi/. This partition contains the installed Linux kernel(s)
as well as the ELILO configuration file (elilo.conf). The elilo.conf file contains a list of kernels
from which you can boot your system.
Red Hat Ent erprise Linux 5 Inst allat ion G uide
8