Installation guide

Figure 29.8. Network Configuration

If the system to be installed via kickstart does not have an Ethernet card, do not configure one

on the Network Configuration page.

Networking is only required if you choose a networking-based installation method (NFS, FTP, or

HTTP). Networking can always be configured after installation with the Network Administra-

tion Tool (system-config-network). Refer to the Red Hat Enterprise Linux Deployment Guide for

details.

For each Ethernet card on the system, click Add Network Device and select the network

device and network type for the device. Select eth0 to configure the first Ethernet card, eth1 for

the second Ethernet card, and so on.

6. Authentication

286