Installation guide

• Dell DRAC

• HP iLO

• IBM RSA II

• IPMI LAN

• RPS10 Serial Switch

This section provides procedures for the following tasks:

• Creating shared fence devices — Refer to Section 5.1, “Creating a Shared Fence Device”.

The procedures apply only to creating shared fence devices. You can create non-shared

(and shared) fence devices while configuring nodes (refer to Section 6, “Configuring Cluster

Members”).

• Modifying or deleting fence devices — Refer to Section 5.2, “Modifying or Deleting a Fence

Device”. The procedures apply to both shared and non-shared fence devices.

The starting point of each procedure is at the cluster-specific page that you navigate to from

Choose a cluster to administer displayed on the cluster tab.

5.1. Creating a Shared Fence Device

To create a shared fence device, follow these steps:

1. At the detailed menu for the cluster (below the clusters menu), click Shared Fence

Devices. Clicking Shared Fence Devices causes the display of the fence devices for a

cluster and causes the display of menu items for fence device configuration: Add a Fence

Device and Configure a Fence Device.

Note

If this is an initial cluster configuration, no fence devices have been created,

and therefore none are displayed.

2. Click Add a Fence Device. Clicking Add a Fence Device causes the Add a Sharable

Fence Device page to be displayed (refer to Figure 2.1, “Fence Device Configuration”).

5.1. Creating a Shared Fence Device