Installation guide

Appendix B. The LVM Configuration Files
98
# the environment variable LVM_SYSTEM_DIR before running the tools.
#
# N.B. Take care that each setting only appears once if uncommenting
# example settings in this file.
# This section allows you to configure which block devices should
# be used by the LVM system.
devices {
# Where do you want your volume groups to appear ?
dir = "/dev"
# An array of directories that contain the device nodes you wish
# to use with LVM2.
scan = [ "/dev" ]
# If set, the cache of block device nodes with all associated symlinks
# will be constructed out of the existing udev database content.
# This avoids using and opening any inapplicable non-block devices or
# subdirectories found in the device directory. This setting is applied
# to udev-managed device directory only, other directories will be scanned
# fully. LVM2 needs to be compiled with udev support for this setting to
# take effect. N.B. Any device node or symlink not managed by udev in
# udev directory will be ignored with this setting on.
obtain_device_list_from_udev = 1
# If several entries in the scanned directories correspond to the
# same block device and the tools need to display a name for device,
# all the pathnames are matched against each item in the following
# list of regular expressions in turn and the first match is used.
# preferred_names = [ ]
# Try to avoid using undescriptive /dev/dm-N names, if present.
preferred_names = [ "^/dev/mpath/", "^/dev/mapper/mpath", "^/dev/[hs]d" ]
# A filter that tells LVM2 to only use a restricted set of devices.
# The filter consists of an array of regular expressions. These
# expressions can be delimited by a character of your choice, and
# prefixed with either an 'a' (for accept) or 'r' (for reject).
# The first expression found to match a device name determines if
# the device will be accepted or rejected (ignored). Devices that
# don't match any patterns are accepted.
# Be careful if there are symbolic links or multiple filesystem
# entries for the same device as each name is checked separately against
# the list of patterns. The effect is that if any name matches any 'a'
# pattern, the device is accepted; otherwise if any name matches any 'r'
# pattern it is rejected; otherwise it is accepted.
# Don't have more than one filter line active at once: only one gets used.
# Run vgscan after you change this parameter to ensure that
# the cache file gets regenerated (see below).
# If it doesn't do what you expect, check the output of 'vgscan -vvvv'.
# By default we accept every block device:
filter = [ "a/.*/" ]
# Exclude the cdrom drive
# filter = [ "r|/dev/cdrom|" ]
# When testing I like to work with just loopback devices:
# filter = [ "a/loop/", "r/.*/" ]
# Or maybe all loops and ide drives except hdc: