Installation guide

c. service clvm d stop, if CLVM has been used to create clustered volumes
d. service fenced stop
e. service cman stop
f. service ccsd stop
3. At system-config-cluster (running on a node that is not to be deleted), in the Cluster
Configurat ion T ool tab, delete the member as follows:
a. If necessary, click the triangle icon to expand the Cluster Nodes property.
b. Select the cluster node to be deleted. At the bottom of the right frame (labeled Properties),
click the Delete Node button.
c. Clicking the Delete Node button causes a warning dialog box to be displayed requesting
confirmation of the deletion (Figure 5.7, “Confirm Deleting a Member”).
Figure 5.7. Confirm Deleting a Member
d. At that dialog box, click Yes to confirm deletion.
e. Propagate the updated configuration by clicking the Send to Cluster button.
(Propagating the updated configuration automatically saves the configuration.)
4. Stop the cluster software on the remaining running nodes by running the following commands at
each node in this order:
a. service rgm anager stop, if the cluster is running high-availability services
(rgm anager)
b. service gfs stop, if you are using Red Hat GFS
c. service clvm d stop, if CLVM has been used to create clustered volumes
d. service fenced stop
e. service cman stop
f. service ccsd stop
5. Start cluster software on all remaining cluster nodes by running the following commands in this
order:
a. service ccsd start
b. service cman start
c. service fenced start
d. service clvmd start, if CLVM has been used to create clustered volumes
e. service gfs start, if you are using Red Hat GFS
f. service rgmanager start, if the cluster is running high-availability services
(rgm anager)
6. At system-config-cluster (running on a node that was not deleted), in the Cluster
Configurat ion T ool tab, verify that the configuration is correct. At the Cluster Status T ool tab
verify that the nodes and services are running as expected.
Chapter 5. Configuring Red Hat Cluster With system-config-cluster
61