Installation guide

Table 2.1. Enabled IP Ports on Red Hat Cluster Nodes
IP Port
Number
Protocol Component Reference to Example of
iptables Rules
6809 UDP cm an (Cluster Manager), for use in
clusters with Distributed Lock
Manager (DLM) selected
Example 2.1,Port 6809: cman”
11111 TCP ricci (part of Conga remote
agent)
Example 2.3,Port 11111: ricci
(Cluster Node and Computer
Running luci)
14567 TCP gnbd (Global Network Block Device) Example 2.4,Port 14567: gnbd”
16851 TCP m odclusterd (part of Conga
remote agent)
Example 2.5,Port 16851:
modclusterd
21064 TCP dlm (Distributed Lock Manager), for
use in clusters with Distributed Lock
Manager (DLM) selected
Example 2.6,Port 21064: dlm
40040,
40042,
41040
TCP lock_gulmd (GULM daemon), for
use in clusters with Grand Unified
Lock Manager (GULM) selected
Example 2.7,Ports 40040, 40042,
41040: lock_gulmd
41966,
41967,
41968,
41969
TCP rgm anager (high-availability
service management)
Example 2.8,Ports 41966, 41967,
41968, 41969: rgmanager
50006,
50008,
50009
TCP ccsd (Cluster Configuration System
daemon)
Example 2.9,Ports 50006, 50008,
50009: ccsd (T CP)”
50007 UDP ccsd (Cluster Configuration System
daemon)
Example 2.10,Port 50007: ccsd
(UDP)”
2.2.2. Enabling IP Ports on Computers That Run luci
To allow client computers to communicate with a computer that runs luci (the Conga user interface
server), and to allow a computer that runs luci to communicate with ricci in the cluster nodes, you must
enable the IP ports assigned to luci and ricci. Table 2.2, Enabled IP Ports on a Computer T hat Runs
luci” lists the IP port numbers, their respective protocols, the components to which the port numbers are
assigned, and references to iptables rule examples. At each computer that runs luci, enable IP ports
according to T able 2.1,Enabled IP Ports on Red Hat Cluster Nodes. (All examples are in Section 2.2.3,
Examples of iptables Rules.)
Note
If a cluster node is running luci, port 11111 should already have been enabled.
Red Hat Enterprise Linux 4 Cluster Administration
20