User`s guide

??????????????????????????????????????????????????????????????????????????????????????????????????????????????????????+???????????????????????×?????????????????????????????????????????????????−26217
Upgrade Procedures
50 RedHawk Linux Version 5.4 Release Notes
mount /dev/dvd /media/dvd
cd /media/dvd
./install-redhawk
NOTES
NOTE 1: Special instructions are displayed during the installation that may
require appropriate action, such as video card installation and
configuration. Follow the on-screen instructions until the installation
script completes.
NOTE 2: The installation script will prompt you to accept or reject the End User
License Agreement. You can view the agreement by entering “v” at the
prompt.
3. When the installation completes, issue the following commands:
cd ..
eject
4. Remove the disc from the drive and store.
5. Reboot the system choosing the new RedHawk kernel and verify that the
system boots properly.
6. Continue to the next step to upgrade FBS.
6.5 Upgrading to Frequency-Based Scheduler (FBS) Version 5.4
If you are using FBS, upgrade to FBS Version 5.4 at this time by performing the following
steps. If you are not using FBS, proceed to “Upgrading to PCI-to-VME Bridge Version 5.4”
on page 45.
1. Insert the updates disc into the drive and issue the following commands: