User`s guide

ManualsBrandsRed Hat ManualsConsumer electronicsENTERPRISE 5.4 RELEASE NOTES

??????????????????????????????????????????????????????????????????????????????????????????????????????????????????????+???????????????????????×?????????????????????????????????????????????????−26217

Installation Procedures

RedHawk Linux Version 5.4 Release Notes 39

c. Install the RPM via the following command:

# rpm -ivh ccur-ntp*.rpm

2. After your system is completely installed, refer to the Real-Time Clock and

Interrupt Module (RCIM) User’s Guide for instructions for configuring ntp.

5.4 Installing Frequency-Based Scheduler (FBS) Software

FBS is an optional package to RedHawk Linux. If you will be using FBS, install it at this time

by performing the following steps:

1. With RedHawk Linux Version 5.4 running, log in as root and take the

system down to single-user mode.

2. Locate the disc labeled “RedHawk Linux Frequency-Based Scheduler

Version 5.4” appropriate to your system’s architecture and insert it into the

optical media drive.

3. If the optical media disc device does not mount automatically, execute the

mount command; for example:

mount /media/dvd

4. To install, execute the following commands:

cd /media/dvd

./install-fbs

Follow the on-screen instructions until the installation script completes.

5. When the installation completes, execute the following commands:

cd ..

eject

6. Remove the disc from the optical media drive and store.

7. Exit single-user mode (Ctrl-D).

5.5 Installing the PCI-to-VME Bridge

If you are using the PCI-to-VME bridge supplied by Concurrent to connect your iHawk system

with a VME system, it can be installed at this time. If you are not installing this feature, skip to

to the next section.

5.5.1 Installing the Hardware

The hardware consists of a PCI adapter, a VMEbus adapter and a fiber optic cable.

NOTE: Concurrent Computer Corporation strongly recommends

that you use an antistatic wrist strap and a conductive foam pad when

installing and removing printed circuit boards.

1. To configure the jumpers on the VMEbus adapter card correctly,

refer to Chapter 10 of the SBS Technologies Model 618-3 Hardware

Manual included with the RedHawk Linux documentation. The PDF