User`s guide

??????????????????????????????????????????????????????????????????????????????????????????????????????????????????????+???????????????????????×?????????????????????????????????????????????????−26217
Installation Procedures
RedHawk Linux Version 5.4 Release Notes 35
Dependency checking is performed, and finally, updating of packages is executed.
No action is required of you during this step.
4. When the update completes, execute the following commands:
cd ..
eject
NOTE: If there is more than one media device, you must specify the device
to be ejected; e.g., eject /dev/hda.
5. Remove the disc from the optical media drive and store.
6. Type “reboot” at the system prompt and verify that the new Red Hat kernel
boots.
7. Continue with the steps in the next section to install RedHawk Linux.
5.2 Installing RedHawk Linux
After completing the installation of Red Hat in the previous section, perform the following steps
to install RedHawk Linux:
1. Log in as root and take the system down to single-user mode:
a. If in GUI mode, right click on the desktop and select Open Terminal.
b. At the system prompt, type init 1.
2. Locate the disc labeled “RedHawk Linux Version 5.4” appropriate to your
system’s architecture and insert it into the optical media drive.
3. If the device does not mount automatically, execute the mount command
appropriate for your optical media device.