User`s guide

??????????????????????????????????????????????????????????????????????????????????????????????????????????????????????+???????????????????????×?????????????????????????????????????????????????−26217
Installation Procedures
RedHawk Linux Version 5.4 Release Notes 19
Select the Fixed size radio button and check the Force to be a
primary partition checkbox.
Select an appropriate size for the root partition. For large disks, a size of
60,000MB is recommended. The remaining space will be used for a partition of
general use in step e below. It is recommended to separate the root partition from
the remainder of the disk to make regenerating systems simpler, avoiding the need
to back up the lion’s share of the disk. For smaller disks, you may want to use all
of the remainder of the disk as the root partition; if so, click the Fill to
maximum allowable size radio button.
In all cases, the root partition should be no less that 12,000MB. The Add
Partition dialog should appear as below, except perhaps for the notation of the
disk in the Allowable Drives section and the specific size you have selected for
the partition. Click the OK button.
d. Click the New button to add the swap partition. Select swap as the
File System Type. Select the Fixed size radio button and check
the Force to be a primary partition checkbox.
Select an appropriate size for the swap partition -- you should specify a size which
matches the amount of physical memory you have in your system, plus 5% (refer
to “File System Swap Size Guidelines” on page 70).
The Add Partition dialog should appear as below, except perhaps for the
notation of the disk in the Allowable Drives section and the specific size you
have selected for the partition.