User`s guide

??????????????????????????????????????????????????????????????????????????????????????????????????????????????????????+???????????????????????×?????????????????????????????????????????????????−26217
Installation Procedures
14 RedHawk Linux Version 5.4 Release Notes
If your system contains disk drives or devices that are
not supported by the Red Hat installation program, you
will need to obtain the necessary driver(s) in order to install Red
Hat Enterprise Linux. A diskette containing the driver may be
included with your system or it may be available on the Red Hat
installation media. If not available, contact the driver
manufacturer for an updated driver or call Concurrent Support
(see "Direct Software Support" on page 83).
For this type of installation, type linux dd at the boot:
prompt. Insert the diskette in the drive when instructed to do so.
If your hard drive is not recognized and no driver
diskette is supplied, a screen appears stating that no hard
drives are found, would you like to select drivers. The installation
disc contains a number of device drivers. Select Yes, then Add
Device to display a list of drivers. Select the desired driver and
proceed through the screens, completing this action by selecting
Done.
5. If you wish to check the Red Hat media, press Enter, otherwise, navigate
to the Skip selection using the Tab key and press Enter to immediately
start the installation.
NOTE: The Source DVD media cannot be checked using this procedure
because Red Hat does not include the required checksum in the DVD
content.