User`s guide

??????????????????????????????????????????????????????????????????????????????????????????????????????????????????????+???????????????????????×?????????????????????????????????????????????????−26217
Installation Procedures
RedHawk Linux Version 5.4 Release Notes 13
5.1.1 Installing Red Hat
This section typically takes between 40-70 minutes to complete.
1. Power on the system, if needed, to open the DVD drawer.
2. Insert Red Hat Enterprise Linux Installation Disc 1 in the drive and power
down the system.
3. Power on the system with the installation disc installed to boot from the
disc. After a short delay, a screen containing the boot: prompt should
appear.
4. Press Enter (or allow this screen to timeout) to start the installation
program using the GUI installation interface.
NOTES
If the installation GUI does not launch:
If you wish to use GUI mode but it does not launch, refer to
section 8.1.6 on page 75 for some boot options that may cause the
GUI to launch. Some NVIDIA cards require specifying the
display resolution at the boot prompt before the install GUI will
start. If successful, continue to follow the installation directions
below.
In addition to GUI mode, Red Hat Enterprise Linux can be
installed in text mode or by using VNC.
In text mode, aids at the bottom of the screen describe how to
navigate through the text mode screens and make selections. The
instructions given in the steps below can be applied to both GUI
and text mode installation; however, the number and order of the
configuration screens differ slightly between the two modes.
If you wish to use VNC for the installation instead of the GUI or
text modes, refer to section 8.1.5 on page 72 for full instructions.