Specifications

Subject to change without notice

Fig. 3.12: Formula editor

In order to change the settings use the soft keys and the universal

knob. Here you can program and store the formulae most used.

As mentioned earlier these formulae can be quickly switched on

and off by pressing the MATH key

and using the appropriate

short soft menue.

3.7 Storingdata

Your HMO can store 5 different kinds of data:

– Instrument settings

– Reference signals

– Signals

– Screen displays

– Sets of formulae.

Signals and screen displays can only be stored on USB sticks.

All other data can be stored either on a USB stick or in the

instrument’s non-volatile memories. In order to store data you

have to dene the kind of data and the destination. First attach

a USB stick to the front panel connector. Press SAVE/RECALL

in order to call the respective menu.

Fig. 3.13: Save/Recall menu

Select the kind of data by pressing the respective soft key (in

this example ) in order to access the settings

menu.

Fig. 3.14: Menu 

Please verify that the USB connector into which you plugged the

USB stick (front or rear) is written in the top soft menue (You

can change the destination by opening the respective menu if

you press the softkey next to ). You can now save a

Screenshot if you press the softkey next to SAVE using the pre-

dened name written in the menu below FILE NAME. You may

name the destination memory with up to 8 characters; in order

to do this select the menu item  and dene the name

by using the universal knob and the CURSOR SELECT key.

Fig. 3.15: Dening a le name

After the soft key next to  was pressed the oscilloscope

will have stored the name and return to the settings menu. Here

you can now store the actual screen display by pressing the

STORE soft key. Alternatively, you can return to a lower menu

level (by pressing the lowest Menu OFF key) and select the

menu item key FILE/PRINT. In the following menu press the soft

menu key next to : this will assign the function