Installation guide

2. Using the Administration Server port number, launch the Console.

/opt/dirsrv/bin/redhat-idm-console -a http://localhost:9830

NOTE

If you do not pass the Administration Server port number with the

redhat-idm-console command, then you are prompted for it at the Console

4. Typical Setup

The typical setup process is the most commonly-used setup process. It offers control over the

ports for the Directory and Administration Servers, the domain name, and directory suffix.

NOTE

Run the setup-ds-admin.pl script as root.

The typical setup has the following steps:

WARNING

If Directory Server is already installed on your machine, it is extremely important

that you perform a migration, not a fresh installation. Migration is described in

Chapter 8, Migrating from Previous Versions.

1. After the Directory Server packages are installed as described in Section 2, “Installing the

Directory Server Packages”, then launch the setup-ds-admin.pl script.

# /opt/dirsrv/sbin/setup-ds-admin.pl

2. Select y to accept the Red Hat licensing terms.

Chapter 4. Setting up Red Hat Directory Server on HP-UX 11i