Specifications

EMC Secure Remote Support Gateway for Linux Release 2.24 Operations Guide

Configuration CLI Commands

Adding a managed

device

To add a managed device, run the manage_device command as in the

following example:

./manage_device --add-device --model CENTERA --host

10.241.185.59 --serialnumber APM00205030103-2

Error: 0

Note: An Error code of 0 as above means successful; any other result

(alpha or numeric) indicates some failure to complete successfully.

Figure 56 Adding a managed device

1. Enter the following device information:

• Model Type

• IP Address

• Serial Number

• Suffix, if applicable

Note: Refer to Table 5, “Valid Suffixes and Code Versions,” on page 72 for the

list of valid suffixes and code versions for each product.

2. After entering the device information, the Configuration CLI

Commands will run a connectivity test. An error message will

appear if the connectivity test fails.

Note: The added device needs to be approved by EMC and may not be

available immediately. The device goes into pending approval state in

ServiceLink, and will not appear as a managed device until approved in

ServiceLink.

3. The update will not take effect until it has been approved by an

authorized EMC Global Services professional via the EMC

enterprise.

Note: The ESRS Portal is located at the following url: esrs.emc.com.

4. Once the request has been approved via the EMC enterprise, and

the synchronization process completes, you can view the device

by running:

manage_device --list