Installation guide

70 EMC NetWorker Release 8.1 SP1 Installation Guide
AIX Installation
Reviewing Console server requirements
This section describes the Console server requirements.
Before installing the Console server software package, review the following requirements:
◆ If you did not install the NetWorker client software on the target host, then install the
NetWorker client software when you install the Console server software.
◆ A NetWorker 8.0 and later Console server software does not support AIX 5.2 and AIX
5.3.
◆ A NetWorker 8.1 Console server does not support AIX 32-bit NetWorker server. The
EMC NetWorker Software Compatibility Guide on the EMC Online Support Site
provides the most up to date information on supported Console server operating
systems.
“Optional, moving the Console server files to a new Console server” on page 43
describes how to migrate a Console server from a previously supported operating
system to a new Console server.
◆ Ensure that there is sufficient disk space to install the Console server software files.
Table 11 on page 70 specifies the default location and space requirements for the
Console server software on an AIX host.
Installing the Console server software
This section describes how to install the Console server software.
1. Log in to the target host as root.
2. Rename the .toc file in the directory that contains the NetWorker software packages.
3. If you installed NetWorker client software on the host:
• Confirm that the NetWorker Remote Exec daemon, nsrexecd is started:
ps -ef | grep nsr
•If the nsrexecd daemon is not started, type:
/etc/rc.nsr
Table 11 AIX Console server default file locations and space requirements
NetWorker package Location Size
LGTOnmc.rte /opt/lgtonmc
/usr/lpp
189 MB
76 KB