Installation guide

EMC NetWorker Release 8.1 SP1 Installation Guide 121
Microsoft Windows Installation

Port 2638 is reserved by the Console server software for TDS protocol
communications with the Console server database. Port 9002 is the preferred port for
EMC Data Protection Advisor product.
12. Click Next.
13. Review the information in the Product Configuration Summary window and click Next.
14. On the Ready to Install the Program window, click Install.
When the Console server software is updated from a version prior to 8.0 and the
database conversion fails:
• The following error message is displayed:
Install failed to upgrade the database full path and database
name . Check the upgrade log full path and log name file for
details.
Please, fix any environment related errors mentioned in the log
and then run the script
full path to gstdbupgrade.sh manually to
upgrade the database after the install is complete.
• The NetWorker and Console server software installation fails. The software is rolled
back to the previous version of the NetWorker and Console server software.
“Reviewing the Console server database conversion status” on page 47 describes
how to determine the cause of the conversion failure and the steps to convert the
database after the software install has completed.
15. On the NetWorker Management Console Setup Completed window, clear Launch the
console client in the default browser immediately after exiting the InstallShield
Wizard, and click Next.
The NetWorker Management Console Setup Completed window provides:
• The location of the install.log file.
• The location of the gstd.raw file.
• The browser URL to specify in a browser window to access the Console server GUI
from any desktop.
16. Optionally, on the NetWorker setup complete window, select Run Change Journal
Manager on exit. The
NetWorker Administration Guide describes how to configure the
NetWorker software to use the Windows Change Journal.
17. Click OK to complete the install.
18. Open Task Manager and ensure that the appropriate NetWorker daemons are started.
Table 3 on page 22 provides a list of the NetWorker daemons.
Installing additional language packs
1. Log in to the target host with a local administrator user.
2. From Control Panel, select the appropriate program to install the application software.
3. Select NetWorker and click Change.