Installation guide

EMC NetWorker Release 8.1 SP1 Installation Guide 105
Solaris Installation
8. During a NetWorker server upgrade only, stop the NetWorker daemons and start them
again.
For example:
nsr_shutdown
/etc/init.d/networker start
9. To confirm that the NetWorker daemons started successfully, type:
ps -ef | grep nsr
“NetWorker daemons” on page 22 provides a list of the daemons that start for each
installation type.
Installing Console server on Solaris
To manage the NetWorker server, install the Console server software on one host in the
datazone.
◆ “Reviewing the Console server requirements” on page 105
◆ “Reviewing the Console server requirements” on page 105
Reviewing the Console server requirements
Review this section before you install the Console server package.
◆ The Console server software supports:
• SolarisAMD64: Solaris 10 & 11
• Solaris SPARC (64-bit): Solaris 10 & 11
The
EMC NetWorker Software Compatibility Guide on the EMC Online Support Site
provides the most up to date information on supported Console server operating
systems.
◆ For Solaris 11 only, the Console server requires the ucblib library. Ensure that the ucb
package is installed on a Solaris 11 server.
To determine if the ucb package is installed, type:
pkg info | grep ucb
To install the ucb package, type:
pkg install compatibility/ucb
◆ When a Solaris 10 Console server is also the NetWorker server, the nsrexecd daemon
might fail to restart with a socket binding error. To resolve this issue, install patch
147440-04 or later for SPARC.
To determine if the patch is applied, type:
showrev -p | grep 147440