Installation guide

multipath {
wwid 360060160eda50800a155ad9b6a54db11
alias DGC_012
}
multipath {
wwid 360060160eda508009f55ad9b6a54db11
alias DGC_013
}
multipath {
wwid 360060160eda508009d55ad9b6a54db11
alias DGC_014
}
multipath {
wwid 360060160eda508009055ad9b6a54db11
alias DGC_015
}
multipath {
wwid 360060160eda508009155ad9b6a54db11
alias DGC_016
}
multipath {
wwid 360060160eda508009255ad9b6a54db11
alias DGC_017
}
multipath {
wwid 360060160eda508009355ad9b6a54db11
alias DGC_018
}
Appendix C: lvm.conf
The following /etc/lvm/lvm.conf file content was used during testing.
# This is an example configuration file for the LVM2 system.
# It contains the default settings that would be used if there was no
# /etc/lvm/lvm.conf file.
#
# Refer to 'man lvm.conf' for further information including the file
layout.
#
# To put this file in a different directory and override /etc/lvm set
# the environment variable LVM_SYSTEM_DIR before running the tools.
# This section allows you to configure which block devices should
# be used by the LVM system.
devices {
# Where do you want your volume groups to appear ?
dir = "/dev"
# An array of directories that contain the device nodes you wish
# to use with LVM2.
#scan = [ "/dev" ]
62 | www.redhat.com