Installation guide

# chkconfig --level 2345 gfs on

# chkconfig --level 2345 clvmd on

# chkconfig --level 2345 cman on

You can then reboot the member for the changes to take effect or run the following commands

in the order shown to restart cluster software:

1. service cman start

2. service clvmd start, if CLVM has been used to create clustered volumes

3. service gfs start, if you are using Red Hat GFS

4. service rgmanager start

6. Diagnosing and Correcting Problems in a Cluster

For information about diagnosing and correcting problems in a cluster, contact an authorized

Red Hat support representative.

Database