Installation guide

Section 3.8.1, “Adding a Failover Domain”
Section 3.8.2, “ Modifying a Failover Domain”
Section 3.8.3, “ Deleting a Failover Domain”
3.8.1. Adding a Failover Domain
To add a failover domain, follow the steps in this section.
1. From the cluster-specific page, you can configure failover domains for that cluster by clicking
on Failo ver D o main s along the top of the cluster display. This displays the failover
domains that have been configured for this cluster.
2. Click Ad d . Clicking Ad d causes the display of the Ad d Fai l o ver Do mai n to C l uster
dialog box, as shown in Figure 3.7, “ luci failover domain configuration dialog box” .
Fig u re 3.7. lu ci f ailo ver d o main co n f ig u rat io n d ialo g b o x
3. In the Ad d Fai l o ver D o mai n to C l uster dialog box, specify a failover domain name
at the Name text box.
Note
The name should be descriptive enough to distinguish its purpose relative to other
names used in your cluster.
Red Hat Ent erprise Linux 6 Clust er Administ rat ion
54