Installation guide

Password
Script
(optional)
passwd _scri
pt
The script that supplies a password for access to the fence
device. Using this supersedes the Passwo rd parameter.
Authentication
Type
auth Authentication type: no ne, passwo rd , or MD 5.
Use Lanplus l anpl us T rue or 1. If blank, then value is Fal se. It is recommended that
you enable Lanplus to improve the security of your connection if
your hardware supports it.
Ciphersuite to
use
ci pher The remote server authentication, integrity, and encryption
algorithms to use for IPMIv2 lanplus connections.
Privilege level pri vl vl The privilege level on the device.
IPMI Operation
Timeout
ti meo ut Timeout in seconds for IPMI operation.
Power Wait
(seconds)
po wer_wai t Number of seconds to wait after issuing a power off or power on
command. The default value is 2 seconds for fence_i pmi l an,
fence_i d rac, fence_i mm, and fence_i l o 4 . The default
value is 4 seconds for fence_i l o 3.
Delay
(optional)
d el ay The number of seconds to wait before fencing is started. The
default value is 0.
lu ci Field cl uster.co n
f At t rib u t e
Descrip t io n
Table A.23, “ RHEV-M REST API (RHEL 6.2 and later against RHEV 3.0 and later)” lists the fence
device parameters used by fence_rhevm, the fence agent for RHEV-M REST API.
T ab le A.23. R H EV- M REST API ( RHEL 6 .2 an d lat er ag ain st RHEV 3.0 an d lat er)
lu ci Field cl uster.co n
f At t rib u t e
Descrip t io n
Name name Name of the RHEV-M REST API fencing device.
IP Address or
Hostname
i pad d r The IP address or hostname assigned to the device.
IP Port
(optional)
i ppo rt The TCP port to use for connection with the device.
Login l o g i n The login name used to access the device.
Password passwd The password used to authenticate the connection to the device.
Password
Script
(optional)
passwd _scri
pt
The script that supplies a password for access to the fence
device. Using this supersedes the Passwo rd parameter.
Use SSL ssl Use SSL connections to communicate with the device.
Power Wait
(seconds)
po wer_wai t Number of seconds to wait after issuing a power off or power on
command.
Power Timeout
(seconds)
po wer_timeo
ut
Number of seconds to wait before testing for a status change
after issuing a power on or power on command. The default
value is 20.
Shell Timeout
(seconds)
shell _ti me
o ut
Number of seconds to wait for a command prompt after issuing a
command. The default value is 3.
Login Timeout
(seconds)
l o g i n_ti me
o ut
Number of seconds to wait for a command prompt after login.
The default value is 5.
Times to Retry
Power On
Operation
retry_on Number of attempts to retry a power on operation. The default
value is 1.
Fence Device Paramet ers
187