Installation guide

48 Chapter 3. Installing and Configuring Red Hat Cluster Suite Software
Field Description
Name A name for the SANBox2 device connected to the cluster.
IP Address The IP address assigned to the device.
Login The login name used to access the device.
Password The password used to authenticate the connection to the device.
Table 3-14. Configuring a QLogic SANBox2 Switch
Field Description
Name A name for the Vixel switch connected to the cluster.
IP Address The IP address assigned to the device.
Password The password used to authenticate the connection to the device.
Table 3-15. Configuring a Vixel SAN Fibre Channel Switch
Field Description
Name A name for the WTI power switch connected to the cluster.
IP Address The IP address assigned to the device.
Password The password used to authenticate the connection to the device.
Table 3-16. Configuring a WTI Network Power Switch
4. Click OK.
5. Choose File => Save to save the changes to the cluster configuration.
3.7. Adding and Deleting Members
The procedure to add a member to a cluster varies depending on whether the cluster is a
newly-configured cluster or a cluster that is already configured and running. To add a mem-
ber to a new cluster, refer to Section 3.7.1 Adding a Member to a Cluster. To add a mem-
ber to an existing cluster, refer to Section 3.7.2 Adding a Member to a Running Cluster. To
delete a member from a cluster, refer to Section 3.7.3 Deleting a Member from a Cluster.