Instructions / Assembly

F.P.O.
(For Positioning Only!)
2CCU
© 2011 Thomas & Betts Corp.
Memphis, TN 38125
www.tnb.com
Made in Mexico
Hecho en México
Fabriqué au Mexique
Lockable Feature
Dispositivo para Candado
Dispositif de verrouillage
GFCI, Duplex, Switch, up to 1 3/8” Rounds
GFCI, Dúplex, interruptor, circular de hasta 1 3/8”
Disjoncteur de fuite à la terre, duplex, interrupteurs,
ronds jusqu'à 35 mm (1 3/8 po)
Installation Options
Opciones de Instalación
Options d’installation
25
For Wet Locations
Para lugares húmedos
Pour endroits humides
For Warranty Information: • Para obtener información sobre la garantia:
Pour informations de garantie : • www.tnb.com/warranty
Weatherproof Receptacle Cover
Tapa de Tomacorriente para Intemperie
Couvercle de prise à l'épreuve des intempéries
97B3
NOTE: Before installing cover, discard plastic plugs from locking features.
1. Install outlet box according to product instructions.
2. Wire electrical devices according to national and local electrical codes.
3. Remove device (receptacle) screws. Remove cut-out areas of gasket to fit appropriate devices. Place gasket over devices. (Fig. 1)
4. Insert and loosely install 4 screws (furnished) through top and bottom small slots in gasket through device holes into box.
Thread screws until heads extend 3/8" from gasket. (Fig. 2)
5. Prepare device for cover installation. GFCI* devices - no adapter needed. Duplex or Switch devices - push adapter pins into
gasket and device. (Fig. 3 & 4). Round devices up to 1-3/8" - remove inner circle of adapter and push pins into gasket and
device. (Fig. 4)
6. Place cover KEYHOLES over screws and "square" cover to box. (Fig. 5)
NOTE: Turn screws fully down (do not over tighten) and then loosen them 1-1/2 turns for proper gasket compression.
7. Use caulk or sealant around cover when installed on an irregular flat surface such as brick or wood siding.
8. TURN ON POWER!
Package Includes:
Cover, Gasket,
4 Adapters, 4 Screws
TA03980 D page 4 of 4
*GFCI NOTE: Alternative GFCI installation (not pictured). Verify GFCI is securely
fastened to box. Remove center from gasket and place over GFCI. Insert (2)
screws (furnished) through top and bottom ROUND holes in cover into
threaded holes in GFCI. Tighten screws. See steps 5 & 6.
FIG. 2
Screws must extend 3/8” from
gasket to mount cover
FIG. 3
Duplex Adapter
FIG. 4
Switch / Round Adapter
FIG. 5
Keyhole
Round Hole
*See GFCI NOTE
Adapter Plate
See Fig. 3 & 4
Push Pin(s)
Push
Pin(s)
into
Gasket
Push
Pin(s)
into
Gasket
Remove circle for Round
FIG. 1
Gasket
WARNING
ELECTRICAL HAZARD! TURN POWER OFF!